Control Hub
Step 1: Add the Support Plate
Parts Needed:
REV-41-1166 – Battery Holder Plate (1)
REV-41-1361 – Nut, Locking, M3 (2)
Step 2: Add the Rev Robotics Control Hub
Parts Needed:
REV-31-1153 – Control Hub (1)
REV-41-1360 – Screw, Hex Cap, M3, 16mm (2) (two other screws are already in the extrusion from an earlier step)
REV-41-1361 – Nut, Locking, M3 (4)
Hint
Reposition the front support beam, if necessary, to accomplish the proper spacing – the two floating screws on the front beam need to be at the corners of the control hub.
Step 3: Add the Left Drive Motor Power Cable
Parts Needed:
Motor Power Cable (1 – comes with the core hex motor – REV-41-1300)
Step 4: Add the Right Drive Motor Power Cable
Parts Needed:
Motor Power Cable (1 – comes with the core hex motor – REV-41-1300)