Front Support Beam
Step 1: Add Screws to Corner Brackets
Parts Needed:
REV-41-1320 – Bracket, Inside Corner (2)
REV-41-1359 – Screw, Hex Cap, M3, 8mm (8)
REV-41-1361 – Nut, Locking, M3 (8)
Hint
Screw the nuts onto the screws just until it’s difficult to turn them; just so that the nuts don’t fall off. The screw heads will need to slide along the center of an extrusion in a later step.
Step 2: Add Corner Brackets to Beam
Parts Needed:
REV-41-1431 – Extrusion, 225mm, 90-90 Degree (1)
Corner Bracket Assemblies (2 - from step 1)
Step 3: Add Floating Screws to Beam
Parts Needed:
Front Beam Assembly (1 - from step 2)
REV-41-1359 – Screw, Hex Cap, M3, 8mm (2)
REV-41-1360 – Screw, Hex Cap, M3, 16mm (2)
Hint
Two of the 8mm screws are loaded onto what will become the front face of the beam.
One of the 8mm and two of the 16mm screws are loaded onto what will become the top face of the beam
Step 4: Add Front Support Beam
Parts Needed:
Chassis (from Back Support Beam, step 4)
Front Support beam assembly (1 - from step 3)
Hint
There should be 121mm between the back support beam and the front support beam (there will be 136mm center to center).
If a ruler is not available, the position may need to be adjusted in a later step.
Step 5: Add Switch Bracket
Parts Needed:
Chassis Switch Plate (part of REV-31-1387)
REV-41-1361 – Nut, Locking, M3 (2)